0

CV Boot Kits

Is your drive shaft flinging grease onto the inside of the wheel, or is the rubber at the CV joint cracked? Then the boot needs replacing before dirt and water can wear out the joint. We bring together CV boot kits for drive shafts: heavy-duty replacement boots, universal boots and repair kits for inner joints.

What does the drive shaft boot do?

The boot is the rubber bellows that encloses the CV joint on a CV axle. It keeps the grease in and water, mud and sand out. If it cracks, grease can be flung out, and dirt can get in and increase wear. If you spot the damage early, it is often enough to replace the boot and repack the joint with fresh grease.

How to choose a CV boot kit

Fitment depends on vehicle, model year and position on the axle. In particular, check:

  • Position: inner or outer joint, front or rear. For example, the QuadBoss kit for the Yamaha YXZ1000R is made for the front inner joint.
  • Model and year: the boots from EPI are listed for specific model years of e.g. Honda, Polaris, Yamaha and Arctic Cat.
  • Design: the EPI boots are designated Heavy Duty, while SPC Performance offers a universal replacement boot where you need to check the joint dimensions yourself.
  • Contents: check whether the kit includes clamps and grease.

Installation and maintenance

The axle typically has to be removed and the joint cleaned thoroughly before fresh grease is added. The clamps must be fitted correctly so the boot seals tightly. Inspect the boots regularly, especially after off-road driving, where branches and rocks can cut the rubber. If there is also play in the driveline, take a look at U-joints or the other parts under driveshafts, chains and couplers.

Frequently asked questions

Can I just replace the boot, or does the whole drive shaft need replacing?

It depends on the condition of the joint. If the boot was replaced early and the joint runs without play or clicking, a new boot and fresh grease can be enough. If dirt has been at work for a long time, the joint may be worn, and a new axle is often the solution.

What is the difference between a universal and a model-specific boot?

A model-specific boot is made for particular vehicles and positions, so the fit is given in advance. A universal boot is not tied to one model, but you need to check yourself that it matches the joint dimensions.

How do I spot a defective CV boot?

Look for cracks, tears or loose clamps, and for grease flung onto the wheel, control arms or underbody. A clicking joint when cornering can indicate that the joint is already worn and that the boot has been leaking for some time.

View as Grid List
Sort by
Display per page

EPI CV Boot Clamp Kit

epiWE145000
EPI CV Boot Clamp Kit
23,75 € excl. VAT

EPI CV Boot Crimp Clamp Kit

epiWE145025
EPI CV Boot Crimp Clamp Kit
23,70 € excl. VAT